Siemens SCALANCE X-200 Operating Instructions Manual page 25

The slot for the C-PLUG is located as follows:
● On the IE Switch X-200 on the back of the device.
● On the IE Switch XF-200 on the left hand side of the device.
Follow the steps below to insert the C-PLUG:
1. Remove the screw cover.
2. Insert the C-PLUG in the slot.
3. Close the slot with the screw cover.
Removing the C-PLUG
It is only necessary to remove the C-PLUG if the IE Switch X-200 develops a fault.
You can lever the C-PLUG out of the slot carefully using flat pliers, tweezers, or a small
screwdriver.
If no C-PLUG is inserted in the device, when the device restarts, an error message is output
in Web Based Management and in the Command Line Interface. In this case, you will need
to set the device to operation without C-PLUG. For further information, refer to the section
"System C-PLUG" in the section on the WBM menu in the configuration manual.
SCALANCE X-200
Operating Instructions, 03/2015, C79000-G8976-C284-06
Description of the device
2.4 The C-PLUG
25