D. Fix the antenna main unit with 4 pcs of nuts using spanner
D-1
Parts required, spanner, four(4) nuts, four(4)
washers and deflector
D-3
Fit the supplied nuts to each of the four bolts
and tighten firmly with spanner
E. Cable holder installation 1
E-1
6 cm
E-2
Drill a 25mm hole (or larger) in the centre of the
tape marking
D-2
Place the antenna and deflector on the aluminium
plate and put the washers over each bolt
D-4
Make sure you check and four (4) nuts are
tightened
Connect signal cable to antenna, place cable holder
and apply electrical tape 5mm from the outside of
the cable holder
※
To avoid cable damage, fix cables as
above image. Keep cables straight in
6cm from the antenna port and make
curves toward cable holder.
E-3
Make sure that hole size is big enough to insert
all cables together by one and one
ENGLISH - 19