Troubleshooting - infaco Powercoup PW2 Assembly Instructions Manual

Remove the tool keys.
Remove any adjustment keys before switching on the tool.
Check whether your tool is damaged.
Before using the tool again, carefully check that the safety features are in perfect working order and whether any
parts have been even slightly damaged.
Have your tool repaired by a specialist.
This tool is compliant with the safety regulations in force. All repairs must be carried out by an Authorized
Service Provider (ASP) or by INFACO and exclusively using original parts. Parts which are not original may
seriously risk the safety to the user.

TROUBLESHOOTING

Problem
Irregular cuts
Low cutting performances
Diagonal cut
Vibrations during cutting
Noise in the extension
Chain noisy when in use.
Tool does not start
Tool suddenly stops
Ref.: NOT TR8
Cause
Sharpening defect
Cutting depth limiter gauge too
big
Sharpening defect
Cutting depth limiter gauge too
small
Sharpening defect
Uneven guide wear
Chain tensioning defect
Sharpening defect
Significant wear of the pinion
Extension guide damaged
Incorrect lubrication
Battery drained
No power to the tool
Safety brake activated
Otros
Too much pressure on the
branches
Overheating
Batería descargada
Otros
36
Solution
Sharpen or replace the chain
Sharpen or replace the chain
Sharpen or replace the chain
File the limiter or replace the chain
Sharpen or replace the chain
Replace the guide
Correct chain tension
Sharpen or replace the chain
Replace the pinion
Contact your dealer
Check and top-up the oil level.
Clean the chain guide and chain.
Contact your dealer
Recharge the battery
Reconnect to power source
Release the safety brake
Contact your dealer
Check chain sharpness
Let the machine cool for 10 minutes
before resuming work
Recharge the battery
Contact your dealer
Index 01.