Hand Pulse Sensor - ProGear 300LS Owner's Manual

ASSEMBLY
Tools:
Open-Ended Flat Wrench
10. Computer Console Installation:
Connect the Extension Sensor Wire (10) coming out from the top side of the Hand Pulse
Handlebar Support Frame (41) to the wire with a male connector coming out from under the
Computer Console (29). Make sure the connectors "click" when connected. Connect the two
Hand Pulse Sensor Wires (35) coming out from the Hand Pulse Handlebar (33) to the two wires
with female connectors coming out from the Computer Console (29). Make sure the connectors
"click" when connected. Attach the Computer Console (29) firmly by sliding the back of the console
onto the Tab located on the top of the Hand Pulse Handlebar (33) then slide it down to lock in
position. See illustration above.
Remove the Nut (58) from the Adjustable Leveler (57). Screw the leveler onto the bottom of the
Mainframe (59) and reinstall the Nut (58) by hand-tightening the nut on to the leveler. Repeat this
for the left side.
IMPORTANT: To prevent the elliptical from wobbling during a workout, make sure you adjust the
levelers as instructed on page 26.
Hardware:
(57) Adjustable (58) Nut
Leveler 2PCS
2PCS
21
22