Right Handrail - ProGear 300LS Owner's Manual

2. Handrails, Foot Bars and Rotation Rod Installation:
Position the Right Foot Bar (17) so that it angles downwards as shown above. Attach the Right
Foot Bar (17) onto the brackets on the bottom end of the Right Handrail (9) with one Bolt (11) and
one Nylon Nut (14). Tighten the bolt until it is firm against the bracket on the Right Handrail (9).
Cover the Bolt (11) and Nylon Nut (14) with two Nut Caps (88).
Using the provided 6mm Allen Wrench, remove the PRE-ASSEMBLED bolts and washers from
both sides of the Rotation Rod (60) and put them to the side. Take the Rotation Rod (60) and
lubricate it with the Grease provided.
Insert the Rotation Rod (60) into the tube on the top of the Mainframe (59) (above the flywheel).
Slide the Right Handrail (9) onto the right end of the Rotation Rod (60) and insert a Bolt (5),
Spring Washer (6), Washer (7), and Waves Washer (22) on to the right end of the Rotation Rod
(60). Do not tighten the Bolt (5) until both handrails have been mounted to the Rotation Rod (60).
Repeat the steps above for installing the Left side parts (75), and (77) onto the Rotation Rod (60).
Use both the 6mm Allen Wrench and the 6mm Allen Wrench with a Phillips Screwdriver to
secure the Bolts (5) on both ends of the Rotation Rod (60). Tighten the both Bolts (5) at the same
time until firm and secure.
Hardware:
(11) Bolt
2PCS
ASSEMBLY
Tools:
6mm Allen Wrench & 6mm Allen Wrench
with Phillips Screwdriver
(14) Nylon Nut
2PCS
11
(88) Nut Cap
4PCS