ProGear 300LS Owner's Manual page 14

.
R for right bolt
Important:
Installing right bolt into right
crank can only be done by
turning right (CLOCKWISE).
3. Foot Pedal Support Bracket and Right Crank Bolt Installation:
Attach the Foot Pedal Support Bracket (18) onto the right side of the Right Foot Bar (17) using
two Bolts (23), two Washers (24), and two Nylon Nuts (25). Use the Open-Ended Flat Wrench
and 6mm Allen Wrench to tighten the Foot Pedal Support Bracket (18) to the Right Foot Bar
(17).
Lubricate the Right Crank Bolt (21) with some of the Grease provided. Insert the Right Crank
Bolt (21) and one Wave Washer (22) through the right holes of the Right Foot Bar (17). Raise the
rear end of the Right Foot Bar (17) and align it with the threaded hold of the Right Crank (26).
Make sure the Right Crank Bolt (21) is perfectly level and straight as you insert it through the hole
of the Right Crank (26). Turn the Right Crank Bolt (21)
hand tightening, completely tighten the Right Crank Bolt (21) with the 8mm Allen Wrench
provided. Put one Spring Washer (27) and one Right Nylon Nut (28) on to the threaded end of the
Right Crank Bolt (21). Use the Open-Ended Wrench on the Right Nylon Nut (28) and the 8mm
Allen Wrench on the Right Crank Bolt (21) simultaneously to tighten the Right Nylon Nut (28).
Cover the Right Nylon Nut (28) with one Cap (97).
Read the note on next page regarding tightening guidelines. Refer to the illustration
showing the correct installation of the Right Crank Bolt (21). See Figure F on the next page.
ASSEMBLY
clockwise
12
Tools:
6mm Allen
Wrench
Open-Ended
Flat Wrench
8mm Allen
Wrench
by hand until it is firm. After