Preparation; Extension Discs; Thread Guide Pole; Cone Holders And Caps - ELNA 624DSE Instruction Manual

PREPARATION
Connect the foot control, pushing the
plug well into the machine plug box.
The ON/OFF s w i t c h turns the light on (I)
or off (0), as well as the supply of electric
current to the motor. Switch on to run the
machine and off when you are not sew-
ing. The electric foot control regulates
motor and sewing speeds. The greater the
pressure on the control, the higher the
speed. Press preferably w i t h the sole of
the foot, not w i t h the toes.
Extension D i s c s
2 transparent discs are supplied w i t h the
machine. Place them at both ends of
the spool pin base, as illustrated, to
avoid thread tangling.
Thread Guide Pole
Pull the thread guide pole up to the highest
position. Make sure that each thread
guide is located exactly above its respec-
tive spool pin.
Cone Holders and C a p s
Both industrial and domestic type thread
spools can be used on the machine. For
industrial spools, the cone holders (a).
For spools w i t h a large diameter, place
the cone holders higher up on the spool
pins or place them w i t h the widest end
on top (see illustration), so that the spools
can be seated firmly on the spool pin
base. Place the spools perpendicularly.
When using domestic type spools, remove
the cone holders and place the caps (b)
over the spools of thread.
Instant Rolled/
Narrow Hem Device
By engaging the lever (c), your machine
sews wider overlock stitches. By dis-
engaging the lever (c), your machine is
ready to sew a rolled/narrow hem, w i t h o u t
changing the needle plate or the presser
foot. To disengage the lever (c), first
open the front door, raise the presser
foot and bring the needle(s) to the highest
or lowest position by turning the flywheel
t o w a r d s to you by hand.
Pull the knob (d) first to the right, and
then swing it down.
To engage the lever (c), take the same
steps, pull the knob (d) to the right, and
then swing it up.