Minor Disorders - ELNA 624DSE Instruction Manual

MINOR DISORDERS
Refer to the following pages for information:
The stitches are irregular or skipped
- Incorrect threading 6-7
- Looper thread guide not set properly. Push it up to the working
position and thread the lower looper 6
- Incorrect thread tension(s) 9, 12, 14, 18-19
- Needle(s) not system EL x 7 0 5 or 130/705H (15 x 1),
of poor quality, bent or not inserted correctly 5
- Pulling fabric: do not pull fabric; guide gently 12
- Incorrect presser foot. Needle plate and/or presser foot
not fitted correctly 5, 11, 2 0
- Thread guide pole not extended or not positioned properly 4
The thread breaks
- Incorrect threading 6-7
- Thread or thread spool tangled 10-12
- Incorrect thread tension(s) 9, 12, 14, 18-19
- When re-threading the lower looper, first remove the
thread from the rear needle 6-7
- Incorrect presser foot. Needle plate and/or presser foot not
fitted correctly 5, 11, 2 0
- Thread guide pole not extended or not positioned properly 4
- Transparent discs not placed on the spool pins 4
- Convertor for 2-thread overlook not fitted correctly (Model 624) 13
The fabric puckers
- Stitch length too long 10, 18-19
- Needle thread tension(s) too tight 9, 14, 18-19
- Foot pressure not suitable for the kind of fabric 11
- Differential feed slide set at more than 1 (Models 6 2 4 & 614) 10
The needle breaks
- By pulling the fabric, the needle strikes the foot or
the needle p l a t e - d o not pull fabric; guide gently 12
- Needle(s) not system EL x 7 0 5 or 130/705H ( 1 5 x 1 ) ,
of poor quality, bent or not inserted correctly 5
- Needle(s) not suitable for the kind of work 5, 18-19
V
The machine jams
- Stitch length too short 10, 18-19
- Needle thread tension(s) too tight 9, 14, 18-19
- Incorrect thread tension(s) 9, 12, 14, 18-19
The machine runs noisily
- Clean and oil 2 0
- Brush both blades 2 0
- Needle blunt or bent 5
- Check thread tension(s) 9, 12, 14, 18-19
The fabric is not cut at all
- Moving blade not engaged correctly 11, 21
The fabric is not cut properly
- Cutting position not set correctly 11, 21
- Moving blade not fitted properly 21
- Brush both blades 2 0
- Moving blade needs replacing 21
The needle breaks when sewing with the moving
blade disengaged
- The edge of the fabric is too far to the right and interferes
w i t h the looper movement 15, 18-19