Aaeon EPIC-5536 Manual page 61

E P I C B o a r d
Exit the MB PnP Mode. Undesired result may occur if the MB PnP
Mode is not exited normally.
(1) Enter the MB PnP Mode
To enter the MB PnP Mode, four special I/O write operations are to
be performed during Wait for Key state. To ensure the initial state of
the key-check logic, it is necessary to perform four write opera-tions
to the Special Address port (2EH). Two different enter keys are
provided to select configuration ports (2Eh/2Fh) of the next step.
87h, 01h, 55h, 55h:
(2) Modify the Data of the Registers
All configuration registers can be accessed after entering the MB
PnP Mode. Before accessing a selected register, the content of
Index 07h must be changed to the LDN to which the register
belongs, except some Global registers.
(3) Exit the MB PnP Mode
Set bit 1 of the configure control register (Index=02h) to 1 to exit the
MB PnP Mode.
WatchDog Timer Configuration Registers
LDN Index R/W Reset Configuration Register or Action
All 02H
07H 71H
07H 72H
07H 73H
07H 74H
Configure Control (Index=02h)
This register is write only. Its values are not sticky; that is to say, a
Address Port
2Eh
W N/A Configuration Control
R/W 00H WatchDog Timer Control Register
R/W 00H WatchDog Timer Configuration Register
R/W 00H WatchDog Timer Time-out Value (LSB)
Register
R/W 00H WatchDog Timer Time-out Value (MSB)
Register
E P I C - 5 5 3 6
Appendix A Programming the Watchdog Timer
Data Port
2Fh
A-3