Command Control operations
Operating your switches in the Command Control environment
Example
Address Switch #1
Set PowerMaster to CMD or traditional
power supplies to full throttle (no more
than 19 volts)
Press SW
Press 1 (the ID#)
Press AUX1 Pass trough
Press AUX2 Turn out
CAB commands for controlling your switches
The switches LED's will change color to follow the switch's throw route.
Note!
For a more in-depth description of the functions of your Cab buttons
Note!
please see the manual that was included with your command system.
71-2045-250 Generic CC switch.indd 6
Pressing SW
Activates the switch protocols in the command base.
Pressing RTE
Activates the route protocols in the command base.
Pressing AUX1
Sets the switch for straight through.
Pressing AUX2
Sets the switch for the curve.
Pressing SET
Used to finalize programming switches
Pressing Number keys (1-99)
Identifies which switch/route will be addressed
Y
our Command-equipped switch
comes factory-programmed with
a switch ID# of "1." To get your switch
in action, set PowerMasters to CMD
or set all power supplies on full (no
more than 19 volts). Press SW and
"1" on your CAB. Press AUX1, AUX2;
your switch is ready for Command
operations.
6
10/7/10 2:44 PM