Radio Settings - Mantracourt T24-ANTA User Manual

Radio Settings

Here you can change the channel and group key for the connected module.
Items you can change:
Channel
Group Key
Reset Module Only
Reset Module and base
Station
Mantracourt Electronics Limited
Select a radio channel between 1 and 15. The default is channel 1. You can use the
Spectrum Analyser mode to determine a good clean channel to use.
Only visible on modules that support
Only modules with identical group keys can communicate. You can isolate groups of
modules on the same channel or just use the key to ensure the data cannot be read
by somebody else. Early versions of T24 modules do not support Group Keys and
this option will not be visible in the Toolkit.
To use modules that support Group Keys with older modules that do not then
the Group Keys must be blank.
The following two options are not visible when changing radio settings for a base
station. In that case changes are immediate.
Only enabled once a change has been made.
When radio settings are changed they do not take effect immediately but require a
reset or power cycle. This button forces the connected module to adopt the new
settings but keeps the base station on the existing settings. The home page is then
shown.
Only enabled once a change has been made.
When radio settings are changed they do not take effect immediately but require a
reset or power cycle. This button forces both the connected module and the base
station to adopt the new changes and re-establishes a connection.
Group Keys.
33
T24 Telemetry User Manual