The solar cell comes with 5 metres of cable as standard longer lengths are available on request. The SP1 & PP1 combined are designed to provide a perpetual power supply for a 12 V system drawing an average of 53mA, even during winter.
It is important when using the PP1 in any configuration that the connections are made in the following order: 1. Connect the 12V output lead to the device you wish to supply. The PP1 is provided with a 5 metre 12V output cable, this cable has the IP67 connector which mates with connection 3, see below.
The PP1 110 - 240Volt AC input has a sealing cap for when it is not connected to the mains. The sealing cap is removed by pushing the outer sleeve towards the case and pulling the cap out. To insert the mains cable input simply align the two parts using the locating grooves on the connector and push in until the outer sleeve locks;...
Hence the SP1 20W panel is more than adequate. The output from the PP1 is fuse protected by a 6.3 Amp anti surge fuse, this is to protect against short circuit on the output, fuses are 6.3A 20x5mm ceramic glass tube type. The 100-240V AC input charger is fuse protected in the 13Amp plug, if this plug is replaced with any other connector please consider how your PP1 is protected.
Warranty The PP1 & SP1 is warranted against defective material and workmanship for a period of (1) one year from the date of dispatch. If the MANTRACOURT ELECTRONICS LTD' product you purchase appears to have a defect in material or workmanship or fails during normal use within the period, please contact your Distributor, who will assist you in resolving the problem.