LoadLifter 5000 Ultimate
Installing the LoadLifter5000 Ultimate System
GETTING STARTED
1 . Raise the vehicle, remove the wheels and obtain normal ride height (Figs . 2 & 3) .
SPECIAL APPLICATION INSTRUCTIONS
1 . For B&W hitch applicatons:
MN-833
Jack stands
a . On B&W part number 1199R, with the hitch in the 49" position only, trim 1/4"
from the bottom of the center flange on the side plate and front cross member
(Fig . 4) . Also, grind a slight chamfer on the back of the front mounting leg of the
upper brackets to clear the bend radius of the large flange on the B&W side plate
(Fig . 4) .
1199R ONLY: Grind the lower edge
of this tab down to accommodate the
upper mounting bracket for this kit.
fig. 2
1199R ONLY: Grind the edge of this
tab down to allow the upper bracket
to butt flush against the B&W bracket.
MINIMUM 8"
between tire
8"
and frame
fig. 3
fig. 4
5