Tips For Installing Air Lines; Securing The Emergency Brake Cable - Air Lift LoadLifter 5000 Ultimate Installation Manual

LoadLifter 5000 Ultimate

SECURING THE EMERGENCY BRAKE CABLE

1 . Attach the supplied clamp around the emergency brake cable and secure it to the
2 . Cut the existing emergency brake cable bracket close to the cable (Fig . 14) .
Cut off existing
brake bracket
close to the
brake cable.
MN-833

TIPS FOR INSTALLING AIR LINES

TIPS FOR INSTALLING AIR LINES
When cutting air lines, use a sharp knife or a hose When cutting air lines, use a sharp knife or a hose
cutter and make clean, square cuts (Fig . 13) . Do not cutter and make clean, square cuts (Fig . E .3) . Do not
use scissors or wire cutters because these tools may use scissors or wire cutters because these tools may
deform the air line, causing it to leak around fittings . deform the air line, causing it to leak around fittings .
Do not cut the lines at an angle . Do not cut the lines at an angle .
Do not bend the 1/4" hose at a radius of less than 1" or Do not bend the 1/4" hose at a radius of less than 1" or
bend the 3/8" hose at a radius of less than 1 1/2" . Do bend the 3/8" hose at a radius of less than 1 1/2" . Do
not put side load pressure on fitting . The hose should be not put side load pressure on fitting . The hose should be
straight beyond the fitting for 1" before bending . straight beyond the fitting for 1" before bending .
Inspect hose for scratches that run lengthwise on hose Inspect hose for scratches that run lengthwise on hose
prior to installation . Contact Air Lift customer service at prior to installation . Contact Air Lift customer service at
(800) 248-0892 if the air line is damaged . (800) 248-0892 if the air line is damaged .
To watch a video demonstrating proper air To watch a video demonstrating proper air
line cutting, go to air-lift .co/cuttingairline . line cutting, go to air-lift .co/cuttingairline .
lower bracket using the previously removed stock bolt . Tighten securely (Fig . 14) .
fig. 13 fig. E.3
Install supplied
clamp around the
emergency brake
cable, securing to
the lower bracket.
fig. 14
9