Ssas Report Test - Furuno Felcom15 Operator's Manual

3.5 SSAS Report Test

You can test for successful transmission of the SSAS report to the address you specify,
without using the button. The test report message states "!!! Test Call !!!" to alert the
receiver of the message that it is a test call.
Note: This function is only available in the SSAS manager mode. Switch to this mode (see
paragraph 3.1.2) and then follow this procedure.
1. Press the [F5] key to open the Reports menu.
2. Press the [4] key to choose the SSAS Report menu.
3. Press the [1], [2], [3], [4] or [5] key as appropriate, and the SSAS report setting menu
appears.
4. Set destination where to transmit the test.
5. Press the [↑] key to choose Status and then press the [Enter] key.
6. Press the [↓] key to choose TEST and then press the [Enter] key.
7. Press the [Esc] key to open the Update window on the FELCOM 15/FELCOM 16 or the
Entry window on the FELCOM 12.
8. Yes is selected; press the [Enter] key. The test report is transmitted. After it is
transmitted, "Status" is automatically set to ON.
9. Press the [Esc] key twice to return to the standby display.
27