Commands Or Queries To The Sound Bar; Replies From The Sound Bar - Neets SB1 Installation Manual

Commands or queries send to the Sound Bar
Commands or queries to the Sound Bar is always structured the same way:
A header: "NEUNIT=1" all commands, queries and replies start with the header
The header and following command is delimited by a comma mark ","
Followed by the command: "POWER=ON"
A command can be changed to a query by replacing the string or number after the equal sign
with a question mark "?"
And ending with a carriage return: "\CR"
Carriage return is commonly referred to as "CR". If you need to enter it in hexdecimal,
the value is 0D and in decimal, it is 13

Replies from the Sound Bar

The Sound Bar will reply with an acknowledgement to a command to indicate that the
command have been accepted
Reply on accepted command:
If a query is sent to the Sound Bar the reply will be equal to the query with the question
mark replaced by the actual string or value matching the query:
Reply to a query:
If the Sound Bar detects an error in the command or query received, the Sound Bar will reply
with the following reply indicating an error.
Reply on errors:
If the Sound Bar is set to Auto On/Off mode by switch on back panel and there is an incom-
ing command, the Sound Bar will reply with the following indicating an error.
Reply when set in Auto On/Off mode:
All RS-232 communications is case sensitive.
!
It is possible to send multiple commands without time delay between commands by
delimiting each command with the command ending \CR.
When adjusting any settings using RS-232 commands the changes will automatically be saved in
the Sound Bar. The saved settings will be used as default values next time power is connected to
the Sound Bar. This function could be used to change the volume in "Auto On/Off" mode.
Page 14 of 16
NEUNIT=1,OK\CR
NEUNIT=1,POWER=ON\CR
NEUNIT=1,ERR\CR
NEUNIT=1,ERR_MODE_SWITCH_IN_AUTO\CR