How To Use; The Mode Select Switch; Auto On/Off Mode; Rs-232 Mode - Neets SB1 Installation Manual

How to use

The mode select switch

The mode selection switch is used to select between RS-232 control mode and Auto On/Off mode.

Auto On/Off mode

When the switch is set in the Auto On/Off mode the Sound Bar will activate the Wake-on-signal
function and work autonomously powering on and off as described in "Wake-on-signal" chapter on
page 12.
In Auto On/Off mode the RS-232 control port will still be active, but the Sound Bar will not react
to incoming commands or queries. Instead, the Sound Bar will reply to a RS-232 command or
query telling the connected control system that the Sound Bar is set to Auto On/Off mode.

RS-232 mode

In RS-232 mode, the RS-232 port will be active. The RS-232 port is used to control the Sound
Bar by commands and status from Sound Bar can be requested by queries.
The Wake-on-signal function will by default be disabled in RS-232 mode. But by RS-232 command
it is possible to activate the function if both Wake-on-signal and RS-232 control is needed for the
application.
To control the Sound Bar by RS-232 connect a control system to the RS-232 port with the
following settings:
• Baudrate: 19.200
• Databit: 8
• Stopbit: 1
• Parity: None
Please be aware that RS-232 control is deactivated if the Sound Bar is set to Auto On/Off mode.
The commands for RS-232 control can be found on page 13.
Page 11 of 16