Wake-On-Signal Technology; Equalizer Presets - Neets SB1 Installation Manual

Wake-on-signal technology

The Sound Bar is equipped with Wake-on-signal technology. This means that the Sound Bar is
able to automatically power on and off, if there is a signal present on one of the three connected
sources.
When the Sound Bar is powered off the Sound Bar will sense on the audio inputs for one second
at a time in a circular manner. means, that the time from activating the source until the Sound
Bar powers on can take up to 3 seconds. To power on the Sound Bar simply output a signal on one
of the connected sources.
When the Sound Bar have powered on the activating input source will be kept as the active source
for as long as there is signal. When the signal is removed the Sound Bar will be kept on for
additional 3 minutes before automatically powering off again. And the wake-on-signall function will
start over again sensing for an active signal.
The volume level for Wake-on-signal will be last stored volume. That means coming from the facto-
ry the Sound Bar will wake up at 0 dB. If another volume level is needed for the specific application
the volume should be adjusted by RS-232 command.
To trigger the Sound Bar to wake the BALANCED and UNBALANCED input need to meet the
specified level mention in the specification section on page 8. Using the correct audio levels will
ensure the best possible user experience of the Sound Bar.
For the optical input an active audio signal shall be present in order for it to be detected as a
active source.

Equalizer presets

Three equalizer presets will provide enhanced listening experience for different use scenarios.
Manual
EQ setting 1 Music - Neutral, default setting
EQ setting 2 Voice - Unified communication setting
EQ setting 3 Presentation - Video/audio streaming setting
The presets can be selected using RS-232 commands.
Page 12 of 16
Device
Music
Voice
Presentation