Installing the base cover
1
Align the base cover tabs to the slots on the edges of the computer.
2
Press the edges of the cover until it clicks into place.
3
Tighten the 8 (M2.5 x 5.0) captive screws to secure the base cover to the computer.
4
Follow the procedure in
Battery
Removing the battery
1
Follow the procedure in
2
Remove:
a
MicroSD card
b
SIM card tray
NOTE:
To remove both cards if equipped and no need to remove the blank filler
c
Base cover
3
To remove the battery:
a
Lift the ribbon, disconnect and remove the battery cable from the connector on the system board [1].
b Remove the 4 (M1.98 x 4 L) screws that secure the battery to the computer [2].
c
Lift the battery from the computer [3].
10
Removing and installing components
After working inside your
computer.
Before working inside your
computer.