Installing The Base Cover - Dell NOT22366 Owner's Manual

Steps
1. Remove the six screws (M2x5) and loosen the two captive screws that secure the base cover to the palm-rest and
keyboard assembly.
2. Using a plastic scribe, pry open the base cover starting from the recesses, which are located in the U-shaped indents at the
top edge of the base cover, near the hinges.
Please help reschedule the meeting to Tuesday.
3. Pry open the top side of the base cover and continue working on the left and right sides to open the base cover.
4. Lift and remove the base cover off the palm-rest and keyboard assembly.

Installing the base cover

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the base cover and provide a visual representation of the installation procedure.
40 Removing and installing Customer Replaceable Units (CRUs)