Removing heat sink assembly
1
Follow the procedure in
2
Remove the:
a
Micro SD
b
SIM card tray
NOTE:
To remove both cards if equipped and no need to remove the blank filler
c
Base cover
d
Battery
3
To remove the heat sink assembly:
a
Disconnect the fan cable from the system board [1].
b Remove the 2 (M2.0 x 3.0) screws that secure the fan to the system board [2].
c
Remove the 4 (M2.0 x 3.0) screws that secure the heat sink to the system board [3].
d Lift the heat sink assembly from the system board.
Installing heat sink assembly
1
Align the heat sink assembly with screw holders on the system board.
2
Replace the 4 (M2.0 x 3.0) screws to secure the heat sink to the system board.
NOTE:
Tighten the screws on the system board in the order of the callout numbers [1, 2, 3, 4] as indicated on the heat sink.
3
Replace the 2 (M2.0 x 3.0) screws to secure the fan to the system board.
4
Connect the fan cable to the connector on the system board.
5
Install the:
a
Battery
b
Base cover
Before working inside your
computer.
Removing and installing components
23