Force Offline (Switch As-I Master Offline); Operation Mode - bihl+Wiedemann AS-i 2.1 User Manual

AS-i/CANopen Gateway
If "Old Address" is selected you can choose the next detected AS
OK-button. The new address for the AS
If an error occurs while addressing a slave, one of the following error messages is
displayed for about 2 seconds:
Failed: SND: slave with old address not detected.
Failed: SD0: slave with address zero detected.
Failed: SD2: slave with new address detected.
Failed: DE:
Failed: SE:
Failed: AT:
Failed: RE:
6.2.3 Force Offline (switch AS
This function shows the actual state of the AS
Yes: AS
No: AS
With "Change" you can modify this state.
Switching the AS
Master has to be in the offline-phase if an AS
IR-interface.
6.2.4

Operation Mode

This function shows the actual operation mode of the AS
Protected Mode: protected mode
Config Mode:
With "Change" you can switch to the other operation mode.
Only in configuration mode parameters and configuration data can be stored.
Subject to reasonable modifications due to technical advances
32
Bihl+Wiedemann GmbH · D-68199 Mannheim · Phone +49-621-339960 · Fax +49-621-3392239 · Internet http://www.bihl-wiedemann.de
Operating by Full-graphic Display
error with deletion of old address.
error with settinng of new address.
new address could only be stored temporarily.
error with reading the extended ID-code 1.
-
i Master offline)
-
i Master is offline.
-
i Master is online.
-
i Master offline puts the AS
configuration mode
-
i slave has to be set with "New Address".
-
i Master:
-
i circuit into the safe state. The AS
-
i slave shall be addressed via the
-
i Master:
Copyright Bihl+Wiedemann, Printed in Germany
-
i slave with the
-
i