Receiver Lithium Battery - SatLab SL800 User Manual

Receiver data transmission signal line, RXD for the receiver data receiving line.
3, through the small five-core connection to external data keys, the external power supply,
the cable connector on the small five-pin red dot on the small five-core interface on the red
dot insertion. If not aligned can not be inserted, and will be small five-core interface and cable
plug damage.
4, computer serial DB9 pin connector signal: 2 (RXD computer data receiving signal line), 3
(TXD computer data transmission signal line), 5 (GND signal ground). Referred to as "2
received 3 hair".

Receiver lithium battery

SL800 has as standard a lithium battery (6300mAh / 3.7V), model BLP-6300S. Technical
process and performance is better than nickel-cadmium or nickel-metal hydride batteries as
it has no memory effect and when not in use has slow self-discharge function.
Warning:
1. Use the standard battery and adapter, do not put the battery into the fire or short-
circuit electrode.
2. If while using or charging the battery, it is found that the battery has heat,
deformation, leakage, odour or other abnormalities you must stop using and replace
with a new battery.
3. in order to extend the battery life, it is recommended for short term storage the
battery is stored in a discharged state
4. For long-term storage, it is recommended to charge the battery once a month to
extend battery life.
`
Figure 5-2 Cable connection diagram
Figure 5-3 lithium battery
32