Introduction; General; Specific Characteristics Thyro-S - AEG THYRO-S 1S*H 1 Series Operating Instructions Manual

1. Introduction

Thyro-S meets the demands for simple assembly, speedy commissi-
oning and safer operation.
For transport, assembly, installation, commissioning, operation and
decommissioning, it is essential that the safety instructions included
in these operating instructions are observed and made available to all
persons handling this product.
In case of uncertainties or missing information, please contact your
supplier.

1.1 General

Thyro-S is a Thyristor switch with the ability to communicate. It will
also be referred to as Power Controller or simply controller. It can be
used wherever voltages or currents need to be controlled in proces-
sing technology. With its good coupling ability to process and automa-
tion technology, high control precision and simple handling, Thyro-S
is also future-orientated for new applications. The Thyro-S is suitable
for a direct supply of ohmic loads.
1.2 Specfic characteristics Thyro-S
Thyro-S has a wide range of distinguishing features, for instance
• easy handling
• type range 230-500 Volts, 16-280 A, single phase, 2-phase and
3-phase structure is possible
• ohmic load
• operating modes 1:1, as well as 1:2, 1:3 and 1:5 (e.g. for commis-
sioning)
• Digital control with 24V signal (> 3V) or via optional bus module
• series system interface
• electrical separation according to EN 50178 chapt. 3
• Connection for optional visualization and commissioning
Options:
• Bus connection via bus adapter
Coupling to different bus systems, e.g. Profibus, Modbus RTU,
58
CANopen and Device Net, other bus systems on request.
• PC software Thyro-Tool Familiy, visual and operational software
1.2.1 Extension using 1S...H RL1
• With additional 24V control voltage supply also applicable for mains
voltages > 0.43 x U
nom
• Load circuit monitoring
• Indication relay
1.3 Type key
The type name of the thyristor switches is based on the construction
of the power unit:
Thyro-S 1S Thyristor switch with 1 phase power unit, suited to
1 phase loads
Example
...400- with 400 Volt type voltage
...280 with 280 Amp type current
H with integrated semi-conductor fuse
F with ventilator (only 280 Amp types)
R with indication relay
L with load monitoring
1 designation Thyro-S, series
The complete type range can be found in chapter 9, TYPE
OVERVIEW.
59
EN