AEG THYRO-S 1S*H 1 Series Operating Instructions Manual page 6

Qualified personnel
Thyro-S may only be transported, installed, connected, commissi-
oned, maintained and operated by specialists in command of the re-
spective applicable safety and installation regulations. All work must
be monitored by the responsible specialist personnel.
Intendet use
CAUTION
The Thyristor switch may only be employed in the sen-
se of its purpose of use (see the section of the chapter
Safety instructions under the same name), otherwise
hazards to persons (e.g. electric shocks, burns) and sy-
stems (e.g. overload) may occur.
Any unauthorized reconstruction and modification of Thyro-S, use of
spare and exchange parts not approved by AEG Power Solutions as
well as any other use of Thyro-S is not permitted.
The person responsible for the system must ensure that
- safety and operating instructions are available and observed,
- operating conditions and specifications are observed,
- protective installations are used,
- maintenance personnel are immediately notified or Thyro-S is imme-
diately put out of commission if abnormal voltages or noises, higher
temperatures, vibrations or similar occur, to determine the causes.
These operating instructions contain all information required by spe-
cialists for the use of Thyro-S. Additional information and notes for
unqualified persons and for the use of Thyro-S outside of industrial
installations are not contained in these operating instructions.
The warranty given by the manufacturer is only valid if these opera-
ting instructions are observed and adhered to.
Warranty
No liability is assumed for employing applications not provided for by
the manufacturer. The responsibility for the necessary measures to
avoid hazards to persons and property is borne by the operator or the
user. In case of complaints, please notify us immediately stating:
54
Type name Production number
Complaint Ambient conditions
Operating mode Duration of use
Guidelines
The CE mark on the device confirms adherence to the general EC
guidelines for 2006/95 EEC – low voltage and for 2004/108 EEC
electromagnetic compatibility if the instructions on installation and
commissioning described in the operating instructions are observed.
55
EN