Safety Instructions - AEG THYRO-S 1S*H 1 Series Operating Instructions Manual

Safety Instructions

The following safety and operating instructions must be careful-
ly read before assembly, installation and commissioning.
Obligation to give instructions
The following safety and operating instructions must be carefully read
before initial assembly, installation and commissioning of Thyro-A by
those persons working with or on Thyro-A.
These operating instructions are part of the Thyristor switch Thyro-S.
The operator of this device is obliged to provide, without restriction,
these operating instructions to all persons transporting, commissio-
ning, maintaining or performing other work on this device.
In accordance with the Product Liability Act, the manufacturer of a
product has an obligation to provide explanations and warnings as
follows:
• the use of the product other than for the intended use,
• the residual product risk as well as
• operating errors and their consequences.
The information given below must be understood in this respect. It is
to warn the product user and protect him and his systems.
Proper use
• The Thyristor switch is a component which may only be used for
control and regulation of electrical energy.
• The Thyristor switch may at most be operated using the maximum
admissible connected load according to information on the type
plate.
• The Thyristor switch may only be operated in connection with a sui-
table and series connected power supply disconnecting device.
• As a component, the Thyristor switch is unable to operate alone and
must be projected for its intended use to minimize residual risks.
• The Thyristor switch may only be operated in the sense of its inten-
ded use, otherwise hazards to persons (e.g. electric shocks, burns)
and systems (e.g. overload) may arise.
47
EN