Table of Contents
Advertisement
Packet Filter – Add TCP/UDP Filter
Rule Name Helper: User defined description for entry identification. You may also choose from
the Select drop-down menu for an existing predefined rule. The maximum name length is 32
characters.
Time Schedule: A self defined time period. You may specify a time schedule for your prioritization
policy. For setup and detail, refer to Time Schedule section.
Source IP Address(es) / Destination IP Address(es): This is the Address-Filter used to allow or
block traffic to/from particular IP address(es). Select the Subnet Mask of the IP address range you
wish to allow/block the traffic to or form. Set the IP address and Subnet Mask to 0.0.0.0 to inactive
the Address-Filter rule.
Tip: To block access, to/from a single IP address, enter that IP address as the Host IP
Address and use a Host Subnet Mask of "255.255.255.255".
Type: It is the packet protocol type used by the application, select TCP, UDP or both TCP/UDP.
Protocol Number: Insert the port number.
Source Port: This Port or Port Ranges defines the port allowed to be used by the Remote/WAN to
connect to the application. Default is set from range 0 ~ 65535. It is recommended that this option
be configured by an advanced user.
Destination Port: This is the Port or Port Ranges that defines the application.
Inbound / Outbound: Select Allow or Block the access to the Internet ("Outbound") or from the
Internet ("Inbound").
When all changes is made, click Add button to apply your changes.
70
Advertisement
Table of Contents
