Table of Contents
Advertisement
Serial Port 5
The sub-items in this menu allow you to set the serial port configuration.
Use This Device [Enabled]
Allows you to enable or disable the serial port (COM). Configuration options:
[Enabled] [Disabled]
Possible [Use Automatic Settings]
Allows you to select the Serial Port base address. Configuration options: [Use
Automatic Settings] [IO=2D0h; IRQ=10;] [IO=2C0h; IRQ=10;]
Serial Port 6
The sub-items in this menu allow you to set the serial port configuration.
Use This Device [Enabled]
Allows you to enable or disable the serial port (COM). Configuration options:
[Enabled] [Disabled]
Possible [Use Automatic Settings]
Allows you to select the Serial Port base address. Configuration options: [Use
Automatic Settings] [IO=2C0h; IRQ=11;] [IO=2D0h; IRQ=11;]
3.3.7
Power Management
Power Mode [ATX Type]
This item selects Power Supply Mode. Configuration options: [ATX Type] [AT
Type]
Restore AC Power Loss [Always Off]
[Always On]
[Always Off]
[Last State]
RTC wake system from S5 [Disabled]
Allows you to enable or disable system wake up on alarm event. When you select [Fixed
Time], the system will wake up on a specified time. When you select [Dynamic Time], the
system will wake up on the current time. Configuration options: [Disabled] [Fixed Time]
[Dynamic Time]
3.3.8
Digital IO Port Configuration
The items in this menu allow you to modify Digital IO settings.
DIO Port 1~4 [Output]
Set DIO data flow as Input or Output. Configuration options: [Input] [Output]
Output Level [High]
Configuration options: [High][Low]
3-8
The system goes into on state after an AC power loss.
The system goes into off state after an AC power loss.
The system goes into either off or on state, whatever
the system state was before the AC power loss.
EMB-APL1
Advertisement
Table of Contents
