Controlling The Monitor With A Computer (Lan); Settings To Connect To A Lan - Sharp PN-L705H Operation Manual

Controlling the Monitor with a computer (LAN)

Your monitor can be connected to a LAN allowing you to
control it from a computer on the LAN.
You can also configure the monitor to send e-mail notification
when it has a problem.
The connection requires a commercially available LAN cable
(UTP cable, Category 5, straight through).
LAN terminal
LAN cable (commercially available, straight)
TIPS
• You must assign an IP address to the monitor by following
the procedures in "Settings to connect to a LAN". (See the
description on the right.)
• Your computer must be installed with the web browser.
• When POWER SAVE MODE is set to ON, control is not
possible in standby mode.
• To control the monitor via LAN, set RS-232C/LAN SELECT
to LAN. (See page 35.)
• You cannot use RS-232C and LAN control simultaneously.
Initializing personal information
• Personal information such as e-mail addresses can be
registered in the monitor. Before transferring or disposing
of the monitor, initialize all settings by selecting ALL RESET
1. (See page 43.) Note that ALL RESET 2 will not initialize
e-mail addresses and other settings.
54
E
Network (LAN)
Hub

Settings to connect to a LAN

Set the monitor's IP address and subnet mask to match the
settings of your LAN.
These settings can be made on either the monitor or a
Computer connected to the monitor.
The settings depend on the configuration of your LAN. Ask
your LAN administrator for details.
nTo set on the monitor
Set RS-232C/LAN SELECT of COMMUNICATION SETTING
on the SETUP menu to LAN, and then set the LAN SETUP
options. (See page 35.)
After setting each item, select SET and press the ENTER
button.
DHCP CLIENT
If your LAN has a DHCP server and you wish to obtain an
address automatically, change this setting to ON.
To set the address manually, set this to OFF.
IP ADDRESS
If the DHCP CLIENT is set to OFF, specify an IP address.
Press the or button to select the items, and enter the
values with the numeric input buttons (0 to 9).
You can also change the values with the
SUBNET MASK
If the DHCP CLIENT is set to OFF, specify the subnet mask.
Press the or button to select the items, and enter the
values with the numeric input buttons (0 to 9).
You can also change the values with the
DEFAULT GATEWAY
If the DHCP CLIENT is set to OFF, specify the default
gateway.
If you are not using a gateway, specify "000.000.000.000".
Press the or button to select the items, and enter the
values with the numeric input buttons (0 to 9).
You can also change the values with the
RESET
Resets the values of the LAN settings to the factory preset
values.
Select ON and then press the ENTER button.
or button.
or button.
or button.