Rs-232C Command Table - Sharp PN-L705H Operation Manual

RS-232C command table

How to read the command table
Command: Command field (See page 44.)
Direction: W When the "Parameter" is set in the parameter field (see page 44), the command functions as described
under "Control/Response Contents".
R The returned value indicated under "Reply" can be obtained by setting "????" or "
parameter field (see page 44).
Parameter: Parameter field (See page 44.)
Reply: Response (Returned value)
* : When POWER SAVE MODE is set to OFF:
"●/○" : Indicates a command which can be used in standby mode or when the power is on.
"–" : Indicates a command which can be used when the power is on. Cannot be used in standby mode.
When POWER SAVE MODE is set to ON:
"●" : Indicates a command which can be used in standby mode or when the power is on.
"○/–" : Indicates a command which can be used when the power is on. Cannot be used in standby mode.
Power control/Input mode selection
Function
POWER CONTROL
INPUT MODE SELECTION
Controlling the Monitor with a computer (RS-232C)
Command Direction Parameter
POWR W 0
1
R
INPS W 0
2
3
10
13
14
18
21
22
R
Reply Control/Response contents
Switches to standby mode.
Returns from standby mode.
0 Standby mode
1 Normal mode
2 Input signal waiting mode
Toggle change for input mode. Terminals not selected in INPUT SELECT cannot
be selected.
D-SUB[RGB]
"ERR" when other than RGB is selected for D-SUB of INPUT SELECT.
D-SUB[COMPONENT]
"ERR" when other than COMPONENT is selected for D-SUB of INPUT SELECT.
HDMI1
HDMI2
DisplayPort 1
HDMI3
OPTION
"ERR" when nothing is attached in the expansion slot.
DisplayPort 2
2 D-SUB[RGB]
3 D-SUB[COMPONENT]
10 HDMI1
13 HDMI2
14 DisplayPort 1
18 HDMI3
21 OPTION
22 DisplayPort 2
?" in the
*
●
47
E