Advertisement
8. About Various Modes
Models MLS-3751 U3781 L are equipped with the following modes. As for the detail, refer to the pages of
respective modes.
Setting mode: Display of processing frequency, history of errors, etc. and settings. etc.
Test mode: Display of temperature and pressure in the chamber, adjustment of thermistors,
pressure sensors, etc.
Demonstration mode: Display of actual operation status and demonstration of operation, etc.
-How to enter into the setting mode
1. Tum ON the power switch.
2. When the
".A. "+
"SET/CONFIRM" buttons are pressed for
about
2
sec. while pressing the "START" button, "Short Beep
x
3" sound is heard and at the same time the decimal point on
the Digital Display I flickers. (See the right figure.)
3. After the status has become such as in
2,
when the "START"
button is pressed within 5 sec. while pressing the
".A."+ "T"
buttons, "Beep· sound is heard, and at the same time the
mode becomes the setting mode and model name and speech
language are displayed.
-How to cancel the setting mode
flicker
"c
sterilization
1- 1
When the power switch is turned OFF, the setting mode is cancelled. Or, when the "STOP" button is
pressed to enter into the test mode and the operation in the "How to cancel the test mode· is performed,
the setting mode reset to the normal mode.
-How to enter into the test mode
A. In stand-by display
Enter into the setting mode according to the procedure in the
"How to enter into the setting mode" and press the "STOP"
button. Then, "Beep" sound is heard and at the same the
mode changes to the test mode. The difference from the
normal mode is such that the decimal point on the Digital
Display I lights up. (See the right figure.)
B. In operation
When the procedure in the "How to enter into the setting
mode" is performed during operation, "Beep· sound is heard
and at the same time the mode changes to the test mode.
-How to cancel the test mode
Flicker
Light-up Sterilization
I
51e
.lizati~
12 1
0:2'1
"c
Time
When the power switch is turned OFF, the test mode is cancelled. Or, when the "START" button is pressed
for about 2 sac. while pressing the
".A."+
"SET/CONFIRM" buttons, "Short Beep X3" sound is heard and
at the same time the test mode returns to the normal mode.
-How to enter into the demonstration mode
1. Turn ON the power switch.
2. Start the reservation operation.
3. When the "Cycle selection"
+
"STOP" buttons is pressed within 5 sec. after starting the reservation
operation, "Beep Beep Beep· sound is heard and at the same time the stand-by is displayed and the
mode changes to the demonstration mode.
-How to cancel the demonstration mode
When the power switch is tumed OFF, the demonstration mode is cancelled.
- 22-
Advertisement
