Delta Electronics AFE075A43A User Manual page 56

Chapter 7 Option CardsAFE2000 Series

Disconnecting CMC- EIP01 from AFEC2000
1. Turn off the AFEC2000 power.
2. Remove the two screws (see Figure 6).
3. Twist opens the card clip and inserts the slot type screwdriver to the hollow to prize the PCB off the card clip
(see Figure 7).
4. Twist opens the other card clip to remove the PCB (see Figure 8).

LED Indicator & Troubleshooting
There are 2 LED indicators on CMC-EIP01. The POWER LED displays the status of power supply, and the
LINK LED displays the connection status of the communication.
LED Indicators
LED
POWER Green
LINK Green
Troubleshooting
Abnormality
POWER LED off
[Figure 6]
[Figure 8]
Status
On Power supply in normal status
Off No power supply
Network connection in normal
On
status
Flashes Network in operation
Off Network not connected
Cause
AFE2000 is not powered
CMC-EIP01 not connected to
AC motor drive
[Figure 7]
Indication
--
Check the power supply.
--
--
Check if the network cable is
connected.
Check if AFE2000 is connected to power supply,
and if the power supply is normal.
Make sure CMC-EIP01 is connected to AFE2000.
7-54
Treatment
Treatment