Care - Radio Shack 900 MHz Digital Spread Spectrum Cordless Phone with Digital Answerer and Caller ID/Call Waiting Deluxe Owner's Manual

Problem
You have an incoming call, but do not
receive any Caller ID information.
The handset battery pack does not
charge.
The TAD does not answer calls.
The TAD does not record callers' mes-
sages.
If you still have problems, disconnect the TAD. If other phones on the same line work properly,
the fault is in this phone or its installation. If you cannot find the problem, take your system to
your local RadioShack store for assistance.

CARE

Keep the phone dry; if it gets wet, wipe it dry immediately. Use and store the phone only in nor-
mal temperature environments. Handle the phone carefully; do not drop it. Keep the phone
away from dust and dirt, and wipe it with a damp cloth occasionally to keep it looking new.
Modifying or tampering with the phone 's internal components can cause a malfunction and
might invalidate its warranty and void your FCC authorization to operate it. If your phone is not
performing as it should, take it to your local RadioShack store for assistance. If the trouble is
affecting the telephone lines, the phone company can ask you to disconnect your phone until
you have resolved the problem.
Suggestion
Let the phone ring twice before you answer so the system
has time to record the Caller ID information.
Check that the system is correctly and securely connected.
Call your phone company to verify that your Caller ID ser-
vice is active.
Check the charging contacts on the handset and base. If
they are dirty, clean them with a pencil eraser.
Be sure the battery pack is connected correctly.
Replace the battery pack.
Make sure the TAD is turned on.
Make sure the AC adapter is properly connected.
Check all phone line connections.
The recording time is set to announcement only. Set it to 1
or 4.
Delete messages if memory is full.
Troubleshooting
31