On A Wall; Connecting, Charging, And Replacing The Battery Pack - Radio Shack 900 MHz Digital Spread Spectrum Cordless Phone with Digital Answerer and Caller ID/Call Waiting Deluxe Owner's Manual

keyhole slots with the wall plate studs
and slide the base down to secure it.
5. Plug the adapter into a standard AC out-
let.
6. Lift the base's antenna to a vertical posi-
tion.

On a Wall

To mount the TAD directly on a wall, you
need two screws of at least 1
(not supplied) with heads that fit into the key-
hole slots on the bottom of the base.
15
1. Drill two holes 3 /
16
apart. Then thread a screw into each
hole, letting the heads extend about
inch (3 mm) from the wall.
2. Plug one end of the supplied long modu-
lar cord into the base's
3. Insert the supplied AC adapter's barrel
plug into the base's
4. Route the adapter cable and modular
cords through the grooves on the base.
5. Align the base's keyhole slots with the
mounting screws and slide the base
down to secure it.
10
3
/ inch long
8
inches (100 mm)
1
/
8
jack.
TEL LINE
jack.
DC IN 9V
Installation
6. Plug the modular cord's other end into
the phone jack.
7. Plug the adapter into a standard AC out-
let.
8. Lift the base's antenna to a vertical posi-
tion.
CONNECTING, CHARGING,
AND REPLACING THE
BATTERY PACK
The phone comes with a rechargeable
nickel-cadmium battery pack in the hand-
set. Before using your phone, you must
connect the battery pack, then charge it for
about 24 hours.
1. Press down and slide off the battery
pack compartment cover.
2. Lift the battery pack out of the compart-
ment.
3. Plug the battery pack's connector into
the socket in the compartment, (the con-
nector fits only one way), replace the
battery pack, and replace the cover.
To charge the battery pack, place the hand-
set either faceup or facedown on the base.
The CHARGE/IN USE indicator on the base
lights.
Note: Be sure the battery pack is properly
connected before you try to charge it. The
CHARGE/IN USE indicator lights when the
handset is on the base even if the battery
pack is not properly connected.
Recharge the battery pack when
flashes on the display.
Notes:
• When you first use the phone after
charging or recharging the battery pack,
the phone might not work and you might
Bemý8Wjj[ho Bemý8Wjj[ho Bemý8Wjj[ho Bemý8Wjj[ho