Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Radio Shack 900 MHz Digital Spread Spectrum CordlessTelephone
Summary of Contents for Radio Shack 900 MHz Digital Spread Spectrum CordlessTelephone
- Page 1 Owner’s Manual Please read before using this equipment.
-
Page 2: Table Of Contents
(not a cordless phone) so you can still make and receive calls if there is an AC power fail- ure. RadioShack and RadioShack.com are trademarks used by RadioShack Corporation. The Sprint Logo is a registered trademark of Sprint Communications Company L.P. Used under license. -
Page 3: Read This Before Installation
READ THIS BEFORE This telephone has been tested and found to comply with all applicable UL and FCC stan- INSTALLATION dards. We have designed your phone to conform to federal regulations and you can connect it to FCC STATEMENT most phone lines. However, each device that you connect to the telephone line draws Your telephone complies with Part 68 of FCC Rules . -
Page 4: Important Safety Instructions
• moving your phone away from the 3. Never install telephone wiring during a receiver lightning storm. • connecting your phone to an AC outlet 4. Never install telephone jacks in wet that is on a different electrical circuit locations unless the jack is specifically from the receiver designed for wet locations. - Page 5 of the type of power supply to your require extensive work by a qualified home, consult your local power com- technician to restore the product to pany. normal operation. 13. Do not allow anything to rest on the • if the product has been dropped or power cord.
-
Page 6: Features
SAVE THESE INSTRUCTIONS ˆ Features Your Sprint 900 MHz Digital Spread Spec- Programmable Ringer — choose from four trum Cordless Telephone uses advanced tone/volume settings for the handset’s ringer. cordless telephone technology to give you Ample Talk and Standby Time — the sup- superior audio quality, range, and security. -
Page 7: Installation
ˆ Installation MOUNTING THE PHONE On a Desk Top You can place the phone’s base on a desk 1. Plug one end of the top or table, or mount it on a wall. Select a lo- supplied long mod- cation that is: ular cord into the jack on TEL LINE... -
Page 8: Connecting And Charging The Battery Pack
3. Insert the supplied AC adapter’s barrel 1. Drill two holes 3 inches plug into the jack as in “On a (100 mm) apart. Then thread DC IN 9V Desk Top,” Step 3. a screw into each hole, let- ting the heads extend about 4. - Page 9 3. Put the battery pack in the compartment. • If the battery pack becomes weak during a call, you hear a beep and the TALK/ 4. Replace the cover. LOW BATT indicator flashes every 3 seconds. Recharge the battery pack. To charge the battery pack, simply place the handset on the base, either face up or face If the battery pack is completely discharged,...
-
Page 10: Setting The Dialing Mode
batteries at the end of their useful life, when 2. Lift the handset, press , and listen TALK taken out of service in the United States or for a dial tone. Canada. The RBRC program provides a con- 3. Press any number other than 0. venient alternative to placing used Ni-Cd bat- teries into the trash or the municipal waste Note: If your phone system requires that you... -
Page 11: Setting The Handset Volume
Note: If the handset is too far from the base, USING TONE SERVICES ON the channel might not be clear. Move closer A PULSE LINE to the base and try making the call again. Some special services, such as bank-by- phone, require tone signals. -
Page 12: Using The Phone Company's Special Services
USING THE PHONE you must subscribe to the services through your phone company. COMPANY’S SPECIAL SERVICES Important: Some phone companies use dif- ferent key sequences to achieve these fea- Your phone supports advanced calling ser- tures. Each section shows the built-in key vices provided by many phone companies, sequence. -
Page 13: Resetting To The Factory Setting
Resetting to the Factory Setting The handset sounds a long beep to indi- cate that the number is stored. To restore a service dial button to its factory 5. For each stored number, write the con- default, lift the handset and press twice tact’s name next to the appropriate loca- then press the service dial button you want to... -
Page 14: Chain-Dialing Service Numbers
Chain-Dialing Service Numbers To connect the headset, pull open the rubber cover marked .on the side of the handset, For quick recall of numbers for special ser- then insert the headset’s plug into the jack. vices (such as alternate long distance or Notes: bank-by-phone), store each group of num- bers in its own memory location. -
Page 15: Care
Problem Suggestion The handset stops working or works poorly Move the handset closer to the base. during a call. Lift the base’s antenna to a fully upright position. Be sure the handset’s battery pack is charged. (If the battery pack power is too low, it does not have enough power to flash the TALK/LOW BATT indicator.) Low volume or unusual sounds. - Page 16 Limited One-Year Warranty This product is warranted by RadioShack against manufacturing defects in material and workman- ship under normal use for one (1) year from the date of purchase from RadioShack company-owned stores and authorized RadioShack franchisees and dealers. EXCEPT AS PROVIDED HEREIN, Ra- dioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE DURATION OF THE WRITTEN LIMITED WARRANTIES CONTAINED...
Need help?
Do you have a question about the 900 MHz Digital Spread Spectrum CordlessTelephone and is the answer not in the manual?
Questions and answers