Setting The Record Time; Selecting The Outgoing Message; Recording/Deleting An Outgoing Message - Radio Shack 900 MHz Digital Spread Spectrum Cordless Phone with Digital Answerer and Caller ID/Call Waiting Deluxe Owner's Manual

3. Repeatedly press
SKIP
the desired number appears.
4. Press to store the setting.
SET/RING
5. Press to exit.
STOP
SETTING THE RECORD
TIME
You can set the recording time to 1, 4, or An-
nounce Only to determine how the TAD will
record incoming messages.
At the 1 or 4 settings, the TAD plays the out-
going message and lets callers leave a mes-
sage up to 1 minute (or 4 minutes) long. At
the Announce Only setting, the TAD plays
the outgoing message but does not let call-
ers leave a message.
1. Press six times. The TAD
MENU
announces "Record time" followed by
the current setting. The display also
shows the current setting (
Announce Only).
2. Press .
SET/RING
3. Repeatedly press SKIP
the desired number appears.
4. Press to store the setting.
SET/RING
5. Press to exit.
STOP
SELECTING THE OUTGOING
MESSAGE
The TAD has two prerecorded outgoing mes-
sages. One asks the caller to leave a mes-
sage: "Hello, no one is available to take your
call. Please leave a message after the tone."
The TAD uses this message when the re-
cording time is set to 1 or 4 (see "Setting the
Record Time").
The other is simply an announcement and
does not let the caller leave a message: "Hel-
24
or until lo, no one is available to take your call.
REPEAT
Please call back another time." The TAD
uses this message when the recording time
is set to Announce Only.
You can also record your own message (see

"Recording/Deleting an Outgoing Message").

When you record your own outgoing mes-
sage, the TAD uses it for all recording time
settings (1, 4, and Announce Only).
To switch between your outgoing message
and the TAD's prerecorded message, press
MENU
setting mode. Then press
until the current message starts to play.
While the message is playing, press
REPEAT
play. The TAD switches to the other mes-
sage and plays it.
Recording/Deleting an Outgoing
Message
' ' ' ' * * * * 7 7 7 7
, , or
Follow these steps to record your own outgo-
ing message (up to 30 seconds long).
1. Press
or REPEAT until
2. Press
3. When the tone sounds, speak your mes-
To delete your outgoing message and use
the TAD's prerecorded messages, press
MENU
message starts to play. The TAD announces
"Deleted."
Answering System Operation
once to enter the outgoing message
SKIP
until the desired message starts to
once. The TAD announces
MENU
"Outgoing message", followed by the
current outgoing message.
. The TAD announces
MEMO/REC
"Record your outgoing message after
the tone."
sage. When you finish your message,
press ,
MEMO/REC STOP
The TAD plays back your message.
once, then press
DELETE
or
REPEAT
SKIP or
## ## ## ##
appears.
, or .
SET/RING
when your