On A Wall Plate Or Wall; On A Desk Top - Radio Shack 900 MHz Digital Spread Spectrum Cordless Phone Owner's Manual

Cautions:
You must use a Class 2 power
!
source that supplies 9V DC and
delivers at least 210 mA. Its
center tip must be set to positive and its
plug must fit the phone's
The supplied adapter meets these speci-
fications. Using an adapter that does not
meet these specifications could damage
the phone or the adapter. The supplied
RadioShack AC adapter was designed
specifically for your phone. Use only the
supplied adapter.
• Always connect the AC adapter to the
phone before you connect it to AC power.
When you finish, disconnect the adapter
from AC power before you disconnect it
from the phone.

On a Desk Top

Follow these steps when you place the base
on a desk, shelf, or table.
1. Plug one end of the supplied long modu-
lar cord into the
TEL LINE
back of the base.
2. Plug the modular cord's other end into a
modular phone line jack.
3. Insert the supplied AC adapter's barrel
plug into the
DC IN 9V
the base.
4. Route the adapter's cord through the
strain relief slot on the base.
5. Plug the adapter into a standard AC out-
let.
6. Lift the base's antenna to an upright posi-
tion.

On a Wall Plate or Wall

jack.
DC IN 9V
jack on the
Note: To mount the phone directly on a wall,
you need two screws (not supplied) with
heads that fit into the keyhole slots on the bot-
jack on the back of
tom of the base.
Follow the steps under "On a Wall Plate or
Wall," then apply these additional instructions
for placement on a wall.
7
1. Plug one end of the supplied short modu-
lar cord into the
TEL LINE
back of the base.
2. Insert the supplied AC adapter's barrel
plug into the
DC IN 9V
3. Route the adapter and modular cords
through the grooves on the bottom of the
base.
4. Plug the modular cord's other end into
the wall plate jack, then align the base's
keyhole slots with the wall plate studs
and slide the base downward to secure it.
5. Plug the adapter into a standard AC out-
let.
6. Lift the base's antenna to an upright posi-
tion.
15
1. Drill two holes 3 /
16
apart. Then thread a screw into each
hole, letting the heads extend about
inch (3 mm) from the wall.
2. Plug one end of the supplied long modu-
lar cord into the
TEL LINE
back of the base.
jack on the
jack.
inches (100 mm)
1
/
8
jack on the