Safety and Care Advice Important - Please read these instructions fully before starting assembly • Warning: This unit weighs • Make sure you have enough • We do not approximately 54kgs. space to layout the parts before recommend the Please lift with care. starting.
Page 3
If you have damaged or missing components, call the Components - Panels Customer Helpline: 03456 400800 quoting the reference numbers below Please check you have all the panels listed below (DF3570) (716 x 494mm) Base (DF4207) (716 x 494mm) Left Side Right Side Hanging Rail (DF4206)
Page 4
If you have damaged or missing components, call the Components - Fittings Customer Helpline: 03456 400800 quoting the reference numbers below Please check you have all the fittings listed below Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings may be supplied than are required.
Page 5
If you have damaged or missing components, call the Assembly Instructions Customer Helpline: 03456 400800 quoting the reference numbers below Step 1 Prepare the 3 drawer fronts Screw 2 metal dowels into each of the drawer fronts Note: Tighten the metal dowels up fully against the panels.
Page 6
Assembly Instructions Step 4 Fit the drawer base Slide the drawer base down the grooves in the drawer sides and down into the groove in the drawer front Step 5 Fit the drawer back Fit the drawer back between the drawer sides Make sure that the drawer base...
Page 7
Assembly Instructions Step 8 Prepare the left side Place 3 runners the left side shown. Slide back the Finished top of runner and use the front edge 2nd hole from the front to fit the 1st screw Slide the runner back the other way and fit the 2nd screw into...
Page 8
Assembly Instructions Step 9 Prepare the right end Push a rail holder into the right end . Make sure that it is fitted straight, in line with the panel edges and then Finished secure with screw front edge Fit 3 hinge plates onto the right end , making...
Page 9
Assembly Instructions Step 12 Prepare the base Tap 2 wooden dowels into the base Finished front edge Step 13 Fit the base Push the base onto the right side secure it with 2 screws Finished front edge Step 14 Prepare the fixed shelf Tap 2 wooden dowels into the fixed shelf Note: Wooden dowels...
Page 10
Assembly Instructions Step 15 Fit the fixed shelf Push the fixed shelf onto the right side and secure it with 2 screws Finished front edge Step 16 Prepare the plinth and Finished back rail top edge Tap 2 wooden dowels into the plinth Tap 2 wooden dowels into the back rail...
Page 11
Assembly Instructions Step 18 Fit the left end Push the left side onto the top , the base , the fixed shelf , the plinth the back rail secure with 8 screws Step 19 Prepare the upright Place 3 runners the upright .
Page 12
Assembly Instructions Step 20 Prepare the internal shelf Screw 2 metal dowels into the internal shelf Tap a wooden dowel Finished into the internal shelf front edge Step 21 Fit the top Push the internal shelf onto the upright Use a screwdriver to tighten the 2 large locking nuts fitted to...
Page 13
Assembly Instructions Step 23 The measurement from top corner X to bottom corner X must be equal to the measurement from top corner Y to bottom corner Y Fit the back Square up the unit by making sure that measurement x to x equals y to y.
Page 14
Assembly Instructions Step 25 Fit the hanging rails and drawers Push the hanging rail into the rail holders Starting with the bottom drawer, slide both the runners forward and locate the drawer sides between them, lining up the holes in the drawer wrap with the 2nd 'threaded' holes in the runners...
Page 15
Assembly Instructions Step 27 Fit doors and handles Note: The easiest way to attach each door is to fit the top hinge first, then align and fit the other hinges. Push the hinge onto the front part of the hinge plate The recess at the bottom of screw B goes into the slot in the hinge plate.
Page 16
Assembly Instructions Step 28 Adjust the doors if needed Before adjusting the doors, use a spirit level to check the base (or top) of the unit is level, front-to-back and side-to-side in the 3 positions shown. Use suitable packing pieces (not supplied) to make the unit level BEFORE making any adjustment to the hinges,...
Page 17
If in doubt, consult an expert. Assembly is complete If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400800 and quote the reference numbers on the component pages. Argos Ltd, 489-499 Avebury Boulevard, Central Milton Keynes, MK9 2NW...
Need help?
Do you have a question about the 402/8583 and is the answer not in the manual?
Questions and answers