For Freezers - Turbo Air TSR-23SD-N6 Installation And Operation Manual

FOR FREEZERS

BASIC OPERATION
TSF-23SD-N
TSF-35SD-N
TSF-49SD-N
TSF-72SD-N
1. Plug in and turn on the power switch located on the bottom of the top grille right
side. The Display panel will be lighted and make a beep sound. The compressor
will begin to run.
2. The default temperature setting is No. "5".
3. The compressor is automatically cycled by the electronic controller
(PCB, F-Sensor).
4. The Defrost cycle is automatically controlled by the D-sensor, and the PCB.
5. Set level toward "1" for higher temperatures and toward "9" for
lower temperatures.
6. The interior light is activated when the door is opened.
7. Evaporator fan motor(s) will run after all doors are completely closed.
8. Good Air Flow in freezer unit is critical.
Items loaded into the freezer should not be pressed against the back wall and
items should be kept 4inches away from the evaporator compartment.
FREEZERS
17