Remove Power From A Switch With Poe - Allen-Bradley ArmorStratix 5700 Installation Instructions Manual

10/100 Ports
1. Insert a straight-through, twisted four-pair, Category 5e or better cable with an M12 D-coded connector into a 10/100 port.
32497
2. Insert the other cable end into the RJ45 or M12 connector in the other device.
100/1000 Ports
Gigabit ports are included only on ArmorStratix 5700 switches with PoE.
1. Insert a straight-through, twisted four-pair, Category 6 or better cable with an M12 X-coded connector into a 100/1000 port.
2. Insert the other cable end into the RJ45 or M12 connector in the other device.
10/100 PoE Ports
For PoE power supply requirements based on your application, refer to
1. Insert a straight-through, twisted four-pair, Category 5e or better cable with an M12 D-coded connector into the PoE port.
32497
2. Insert the other cable end into an M12 or RJ45 connector on the other PoE powered device.

Remove Power from a Switch with PoE

Switches with PoE capability in the following configuration require special instructions to disconnect power:
• The switches are connected to the same power supply
• The PoE ports on both switches are connected to each other via Ethernet cables
If you use the above configuration, you must disconnect both DC+ and DC- connections to power down an individual switch.
32497
Rockwell Automation Publication 1783-IN017A-EN-P - July 2017
page 7.
ArmorStratix 5700 Ethernet Managed Switches
9