Allen-Bradley ArmorStratix 5700 Installation Instructions Manual
Ethernet managed switches
Hide thumbs
Also See for ArmorStratix 5700:
- Product information (4 pages) ,
- User manual (548 pages) ,
- User manual (418 pages)
Table of Contents
Advertisement
Installation Instructions
Original Instructions
ArmorStratix 5700 Ethernet Managed Switches
Catalog Numbers 1783-ZMS8TA, 1783-ZMS16TA, 1783-ZMS24TA, 1783-ZMS4T4E2TGP, 1783-ZMS4T4E2TGN, 1783-ZMS8T8E2TGP,
1783-ZMS8T8E2TGN
Topic
Page
4
4
4
5
5
6
7
8
8
9
10
10
11
Advertisement
Table of Contents
Related Manuals for Allen-Bradley ArmorStratix 5700
Summary of Contents for Allen-Bradley ArmorStratix 5700
-
Page 1: Table Of Contents
Installation Instructions Original Instructions ArmorStratix 5700 Ethernet Managed Switches Catalog Numbers 1783-ZMS8TA, 1783-ZMS16TA, 1783-ZMS24TA, 1783-ZMS4T4E2TGP, 1783-ZMS4T4E2TGN, 1783-ZMS8T8E2TGP, 1783-ZMS8T8E2TGN Topic Page Parts List Required Tools Site Requirements Mount the Switch Ground the Switch Connect the Switch to a DC Power Source... - Page 2 ArmorStratix 5700 Ethernet Managed Switches ATTENTION: Read this document and the documents listed in the Additional Resources section about installation, configuration and operation of this equipment before you install, configure, operate or maintain this product. Users are required to familiarize themselves with installation and wiring instructions in addition to requirements of all applicable codes, laws, and standards.
- Page 3 ArmorStratix 5700 Ethernet Managed Switches Environment and Enclosure ATTENTION: This equipment is intended for use in overvoltage Category II applications (as defined in IEC 60664-1), at altitudes up to 2000 m (6562 ft) without derating. This equipment is not intended for use in residential environments and may not provide adequate protection to radio communication services in such environments.
-
Page 4: Parts List
ArmorStratix 5700 Ethernet Managed Switches Parts List Verify that you have these items. ArmorStratix™ 5700 switch Documentation At the end of its life, this equipment should be collected separately from any unsorted municipal waste. Required Tools Obtain these tools: • An IP67-rated cordset or patchcord with a female-end, 4-pin mini connector to provide 24V DC power to the switch •... -
Page 5: Mount The Switch
ArmorStratix 5700 Ethernet Managed Switches Mount the Switch ATTENTION: To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure that the system remains stable. The following guidelines are provided to ensure your safety: •... -
Page 6: Connect The Switch To A Dc Power Source
ArmorStratix 5700 Ethernet Managed Switches 5. Insert the ground screw into the functional ground screw opening on the front panel. 32545 6. Use a ratcheting torque screwdriver to tighten the ground screws and ring terminal lugs to the switch front panel to 0.4 N m (3.5 lb... -
Page 7: Wire External Alarms
ArmorStratix 5700 Ethernet Managed Switches Power over Ethernet For switches with Power over Ethernet (PoE) capability, PoE power is drawn from the single power connection. There is no separate power input for PoE. Switch Configuration Required Power Input Power Supplied per Port 44-57V 15.4 W, max... -
Page 8: Install Or Remove The Sd Card
ArmorStratix 5700 Ethernet Managed Switches Alarm Relay Connector Labels Label Connection Alarm Output Normally Closed (NC) connection Alarm Input Reference Ground connection Alarm Input 1 ATTENTION: The input voltage source of the alarm output relay circuit must be an isolated source and limited to less than or equal to 24V DC, 1.0 A or 48V DC, 0.5 A. -
Page 9: Remove Power From A Switch With Poe
2. Insert the other cable end into the RJ45 or M12 connector in the other device. 100/1000 Ports Gigabit ports are included only on ArmorStratix 5700 switches with PoE. 1. Insert a straight-through, twisted four-pair, Category 6 or better cable with an M12 X-coded connector into a 100/1000 port. -
Page 10: Confirm Installation
ArmorStratix 5700 Ethernet Managed Switches Confirm Installation To confirm the installation, power on the switch, and verify that the switch powers up. The time that is required for the switch to start up is directly related to your switch configuration. Start time is negatively affected by such things as the following: •... -
Page 11: Additional Resources
Provides declarations of conformity, certificates, and other certification details. http://www.rockwellautomation.com/global/certification/overview.page You can view or download publications at http://www.rockwellautomation.com/global/literature-library/overview.page. To order paper copies of technical documentation, contact your local Allen-Bradley distributor or Rockwell Automation sales representative. Rockwell Automation Publication 1783-IN017A-EN-P - July 2017... -
Page 12: Documentation Feedback
Rockwell Automation maintains current product environmental information on its website at http://www.rockwellautomation.com/rockwellautomation/about-us/sustainability-ethics/product-environmental-compliance.page. Allen-Bradley, ArmorStratix, Rockwell Automation, Rockwell Software, and Stratix are trademarks of Rockwell Automation, Inc. Trademarks not belonging to Rockwell Automation are property of their respective companies. Rockwell Otomasyon Ticaret A.Ş., Kar Plaza İş Merkezi E Blok Kat:6 34752 İçerenköy, İstanbul, Tel: +90 (216) 5698400...