Advertisement

User Manual
Dishwasher
PV1546

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PV1546 and is the answer not in the manual?

Questions and answers

Summary of Contents for Progress PV1546

  • Page 1 User Manual Dishwasher PV1546...
  • Page 2: Table Of Contents

    2 Progress CONTENTS Safety information Before first use Safety instructions Daily use Product description Hints and tips Control panel Care and cleaning Programmes Troubleshooting Settings Technical information Subject to change without notice. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions.
  • Page 3: Safety Instructions

    Progress 3 Do not change the specification of this appliance. • The operating water pressure (minimum and maximum) • must be between 0.5 (0.05) / 8 (0.8) bar (MPa) Obey the maximum number of 13 place settings. • If the supply cord is damaged, it must be replaced by the •...
  • Page 4: Water Connection

    4 Progress • Connect the mains plug to the mains mains socket. Contact the Authorised socket only at the end of the Service Centre to replace the water installation. Make sure that there is inlet hose. access to the mains plug after the installation.
  • Page 5: Product Description

    Progress 5 PRODUCT DESCRIPTION Upper spray arm Rinse aid dispenser Lower spray arm Detergent dispenser Filters Cutlery basket Rating plate Lower basket Salt container Upper basket Air vent CONTROL PANEL On/off button Programme button Programme indicators Indicators...
  • Page 6: Programmes

    6 Progress Indicators Indicator Description End indicator. Salt indicator. It is always off while the programme operates. PROGRAMMES Programme Degree of Programme Consumption values soil phases Type of load Dura‐ Energy Water tion (kWh) (min) Normal soil • Pre-wash 1.039 Crockery and •...
  • Page 7: Settings

    Progress 7 SETTINGS Programme selection mode and How to enter user mode user mode Make sure the appliance is in programme When the appliance is in programme selection mode. selection mode it is possible to set a To enter the user mode, press and hold programme and to enter the user mode.
  • Page 8 8 Progress German de‐ French de‐ mmol/l Clarke de‐ Water softener grees (°dH) grees (°fH) grees level 11 - 14 19 - 25 1.9 - 2.5 13 - 17 4 - 10 7 - 18 0.7 - 1.8 5 - 12 <4...
  • Page 9: Before First Use

    Progress 9 CAUTION! If children have access to the appliance, it is advised to deactivate AirDry as opening the door may pose a danger. How to deactivate AirDry Make sure the appliance is in user mode. 1. Press the programme button twice.
  • Page 10: Daily Use

    10 Progress CAUTION! Only use rinse aid specifically designed for dishwashers. 1. Press the release button (D) to open the lid (C). 2. Pour the rinse aid in the dispenser (A) until the liquid reaches the fill level 'max'. 3. Remove the spilled rinse aid with an absorbent cloth to prevent too much 4.
  • Page 11: Standby Mode

    Progress 11 Setting and starting a 2. Press the on/off button to activate the appliance. programme Make sure that the appliance is in programme selection mode. Standby mode • If the salt indicator is on, fill the salt container. The standby mode decreases energy 3.
  • Page 12: Hints And Tips

    12 Progress Make sure that there is detergent in the Do not try to close the detergent dispenser before you start a appliance door within 2 minutes new programme. after AirDry automatically opens it, as this may cause End of the programme damage to the appliance.
  • Page 13: Loading The Baskets

    Progress 13 2. Make sure that the salt and rinse aid • Make sure that the spray arms can containers are full. move freely before you start a 3. Start the shortest programme with a programme. rinsing phase. Do not add detergent Before starting a programme and do not load the baskets.
  • Page 14: Cleaning The Spray Arms

    14 Progress 1. Turn the filter (B) counterclockwise and remove it. 7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. 2. Remove the filter (C) out of filter (B).
  • Page 15: Troubleshooting

    Progress 15 • If you regularly use short duration • To maintain the performance of your programmes, these can leave deposits appliance at its best, we recommend to of grease and limescale inside the use monthly a specific cleaning product appliance.
  • Page 16 16 Progress Problem and alarm code Possible cause and solution The appliance does not drain the wa‐ • Make sure that the sink spigot is not clogged. ter. • Make sure that the drain hose has no kinks or •...
  • Page 17 Progress 17 The washing and drying results are not satisfactory Problem Possible cause and solution Poor washing results. • Refer to "Daily use", "Hints and tips" and basket load‐ ing leaflet. • Use more intensive washing programmes. • Clean spray arm jets and filter. Refer to "Care and Cleaning".
  • Page 18: Technical Information

    18 Progress Problem Possible cause and solution There are residues of deter‐ • The detergent tablet got stuck in the dispenser and gent in the dispenser at the therefore was not completely washed away by water. end of the programme.
  • Page 19: Environmental Concerns

    Progress 19 Power consumption Off-mode (W) 0.50 1) Refer to the rating plate for other values. 2) If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot water supply to decrease energy consumption.
  • Page 20 156920170-A-232017...

Table of Contents