Vpn - D-Link DSL-5300 User Manual

Section 4 - Configuration
This page allows you to configure the DSL-5300 as a VPN server. We recommend
configuring Dynamic DNS before proceeding with VPN setup. If your router is
assigned an IP address from your ISP using DHCP, it may frequently change, requiring
clients credentials to be set up again and a simple DDNS address will be easier than
an IP address.
Enable PPTP Select to enable the PPTP VPN server.
VPN Server:
Username: Enter the Username that will be required to log into the server
remotely.
Password: Enter the Password that will be required to log into the server
remotely.
Select Enable to enable support for SAMBA and Windows networking
Network
Place (Samba) over the PPTP connection.
Support:
Note that this will expose your network to anyone able to log in.
Select to Enable broadcast support over PPTP.
Broadcast Select to enable broadcast support over VPN connections.
Support:
Authentication: Choose the authentication protocol type: Auto, MSCHAPv1, and
MSCHAPv2. Auto is the default.
MPPE Select encryption to be supported by the PPTP tunnel. Choose from
Encryption: MPPE-128 or MPPE-40 from Microsoft Point-to-Point Encryption
(MPPE). Select No Encryption to disable encryption. Select multiple
options to allow the client to choose between them.
Connect to Select to automatically connect to the router's DNS server to resolve
DNS Server DNS queries.
automatically:
D-Link DSL-5300 User Manual

VPN

80