Update Control; Update Procedure - Delem DA-52s Installation Manual

1.2. Update control

1.2.1. Update procedure

The control can be upgraded with new software. Before you commence an update make sure
you have a backup of all your data, such as products, tools, machine parameters, etc.
New software can be loaded from a portable USB drive. A CD-ROM with the latest control
software can be requested at Delem. It contains all software necessary to perform an update.
To prepare for an update, copy the contents to the USB disk.
Note:
•
When the update program has finished the installation procedure, the control needs to
reboot. Therefore, do not disconnect the USB disk until the update has been completed.
The update procedure runs as follows:
•
Insert the portable USB Drive into an available USB port;
•
on the control, go to the machine parameter menu and choose "Controller software".
The control will search for a valid update set on the USB disk. If it is found, the installation
program will start:
The program starts with a recommendation to make a backup of the currently installed
software. See the next section for more about the backup procedure.
Although a backup is recommended here, you are not obliged to follow this advise. If you do
not wish to make a backup, press the key "N" (Continue>>) to proceed.
Figure 1.a
Delem
V0614, 2.3