How To Clean The Product; Replaceable Parts - Fluke 52120A User Manual

52120A
Users Manual
There must be 19 inches of clearance behind the Product to remove the air
filter.
4. Pull the air filter out of the Product.
5. Clean the air filter with soapy water.
6. Dry the air filter thoroughly.
7. Install the air filter and tighten the knurled screws.

How to Clean the Product

Clean the external surfaces of the Product with a soft cloth dampened with water or a
non-abrasive solution that will not damage plastic.
To prevent damage to the Product, do not use aromatic
hydrocarbons or chlorinated solvents to clean the Product.
These can cause damage to the plastic parts of the Product.

Replaceable Parts

Table 4-2 is a list of replaceable parts. To order parts, see the How to Contact Fluke
section in Chapter 1.
Rear Interconnect Cable
52120A-4412 Cable, High Current 52120A (set of three)
Lead Kit, 52120A Volt/Current (set of two)
4-4
Note
W Caution
Table 4-2. Replaceable Parts
Part Fluke Part No.
4101345
4101350
4044919