Table of Contents
Advertisement
2. Press the
(POWER) button on the projector cabinet
or the POWER ON button on the remote control.
The POWER indicator goes from a steady red light to
a flashing blue light, and the picture is projected on the
screen.
• If using the remote control, press the POWER ON but-
ton.
• When there is no signal the unit will project a blue screen
(factory default menu settings).
• If the picture is blurry, adjust the screen focus. (→ page
33)
• When it is dark press the
panel backlight and the LED lamp on the right side of
the projector will turn on.
TIP:
• The unit has a Power On Shutter function that allows the light
source to turn off even when connected to a power source. (→
page 49)
• Pressing the button will not activate the unit when the KEY LOCK
indicator is flashing orange. (→ page 61)
• When the message "PROJECTOR IS LOCKED! ENTER YOUR
PASSWORD." is displayed, it means that the [SECURITY]
feature is turned on.
After you turn on your projector, ensure that the computer
or video source is turned on.
NOTE: The blue screen ([BLUE] background) is displayed when no
signal is being input (by factory default menu settings).
Performing Lens Calibration
• After installing or replacing the lens unit (below *) sold
separately, press the LENS CALIBRATION button on the
projector, or hold down the CTL button on the remote control
then press the INFO/L-CALIB. button to carry out [LENS
CALIBRATION].
By carrying out [LENS CALIBRATION], the adjustment
range of the zoom and focus of the [LENS MEMORY] is
calibrated.
If you need to install or replace the lens unit, contact your
dealer and have them do it for you.
(lights) button.The indicator
3. Projector Adjustment and Connecting
Standby
Steady red light
26
Blinking
Power On
Blinking blue
Steady blue
light
light
Advertisement
Table of Contents
