Installation For Tilt-Free And Portrait Projection - NEC PH1202HL Installation Manual

Hide thumbs Also See for PH1202HL:
Table of Contents

Advertisement

1-2. Installation for Tilt-free and Portrait projection

This projector can be set to any angle within a vertical 360° range,
however, it cannot be installed with right or left slant besides the portrait
projection.
If you install the projector vertically you can project screens from your
computer and other sources in portrait orientation.
Precautions for the portrait insntallation
Do not simply set the projector vertically on the floor or on a table. The projector may fall over, resulting in injury,
damage or malfunction. Also the intake vent may become blocked causing the unit's internal temperature to
rise resulting in malfunction and risk of fire.
For portrait installation the intake vents must be installed at the top and bottom. To ensure air flow to the bottom
intake vent, a rack to support the unit is necessary. Please hire an installation service provider (for a fee) to
make a custom portrait projection stand.
When installed in portrait orientation the projector can be tilted forward or backward
within a range of ± 10°. Tilting the projector forward or backward outside of this range, or tilting it to the left or
to the right could cause it to malfunction.
To ensure air flow, maintain 30 cm/11.8" of space between the intake
vent and the installation surface.
(NOTE) In the figure to the right there is plenty of space behind, above,
and on either side of the projector unit.
1. Before Setting Up Your Projector
2
Intake vent
Intake vent

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ph1002hl

Table of Contents