Related Manuals for Videofied W Panel
Summary of Contents for Videofied W Panel
- Page 1 W and WIP Panel I N S T A L L A T I O N M A N U A L Doc. - Ref. 230-WIP210 Last modification date : February 2015 Firmware version : XLP 05.21.03.XXX and later WIP210 Panel www.videofied.com...
-
Page 2: Introduction
This panel is intended for residential and commercial markets. ® Like all the Videofied alarm panels, the W panel is compatible with every radio device manufactured by RSI VIDEO TECHNOLOGIES. Technology ®... -
Page 3: Table Of Contents
1.6 Indicator lights.....................6 1.7 Pairing the keypad....................6 2. W panel programming................... ETHERNET parameters configuration................11 3. W panel features guide..................3.1 Get to access level 4..................15 3.2 How to arm/disarm the system................15 3.3 Arming and siren mode configuration..............16 3.4 Manage badges and access codes................17 3.5 Delete the keypad....................19... -
Page 4: W Installation And Setup
COM button INIT button Locking screws 1.2 Panel mounting Fix the back casing on the wall using the three mounting holes (4 mm diameter) as shown. Bracket holes Mounting the panel is not required for programming. W and WIP Panel www.videofied.com... -
Page 5: Ethernet Cable Connexion
1 second. • The red LED blinks several times then turns off. That procedure resets the panel memory. ® • The panel is now reset, a Videofied keypad has to be enrolled to configure the panel. W and WIP Panel www.videofied.com... -
Page 6: Indicator Lights
• Do not mount the keypad. It will display on of the following screens: RSI (c) 2015 <=========XX=========> videofied.com • Press on both ESC NO keys at the same time and release. The indicator LED on the keypad will blink rapidly. Wait for the keypad to pair. -
Page 7: W Panel Programming
I N S T A L L A T I O N 2. W panel programming M A N U A L Use the keypad to program the panel Keypad Display Actions and comments KEYPAD 1 RECORDED OK or YES... - Page 8 I N S T A L L A T I O N 2. W panel programming M A N U A L CODE NAME : You may name the installer code using the alphanumeric keypad. OK or YES If using automatic setting (called installer default list), enter the name of the list.
- Page 9 I N S T A L L A T I O N 2. W panel programming M A N U A L TEST (hour) : OK or YES TEST (minutes) : 04:15 OK or YES CODE / TEST MODIFICATION? OK or YES The CODE/STATE MODIF.
- Page 10 The 2G3G level test can last several minutes. Do not interrupt the test or remove the SIM card during the test. 2G3G LEVEL ? IMPORTANT : Videofied will require a 3/5 grade or better for reliable transmission of Video alarms. W and WIP Panel...
-
Page 11: Ethernet Parameters Configuration
I N S T A L L A T I O N 2. W panel programming M A N U A L ETHERNET parameters configuration Only for models WIP 210/220/230, WIP 620/630 and WIP 720/730 PARAMETERS ? OK or YES... - Page 12 I N S T A L L A T I O N 2. W panel programming M A N U A L For full compatibility with EN50131 norms, press COMPATIBILITY EN 50131 NORMS ? Otherwise, press ESC NO. OK or YES...
- Page 13 I N S T A L L A T I O N 2. W panel programming M A N U A L RF TEST OK or YES RADIO RANGE TEST? Each device is recorded in an area. Each area can be configured as delayed or immediate. Areas are used to set up special arming modes as well.
- Page 14 I N S T A L L A T I O N 2. W panel programming M A N U A L When the configuration is over, close the panel box as shown below and lock the panel. You can find screws to lock the panel inside the box (see chapter 1.1 on page 4).
-
Page 15: W Panel Features Guide
I N S T A L L A T I O N 3. W panel features guide M A N U A L 3.1 Get to Access level 4 Tue 29/10 11:23 ACCESS LEVEL ACCESS LEVEL OK or YES DISARMED... -
Page 16: Arming And Siren Mode Configuration
I N S T A L L A T I O N 3. W panel features guide M A N U A L 3.3 Arming and Siren Mode Configuration • to go to menu : CONFIGURATION (LEVEL 4) > SPECIAL ARMING MODES > FULL ARM, SP1 or SP2 •... -
Page 17: Manage Badges And Access Codes
I N S T A L L A T I O N 3. W panel features guide M A N U A L 3.4 Manage badges and access codes Access Level Access Level Definition & Rights LVL 1 Standby Level LVL 2 Restricted USER level, where it is only possible to arm/disarm the system. - Page 18 I N S T A L L A T I O N 3. W panel features guide M A N U A L Enter a new end user Badge/Code Delete an end user Badge/Code BADGES ENTER A ACCESS CODES BADGE/CODE...
-
Page 19: Delete The Keypad
I N S T A L L A T I O N 3. W panel features guide M A N U A L 3.5 Delete the keypad or any other device ACCESS LEVEL CONFIGURATION OK or YES GENERAL AREAS AND... -
Page 20: Read The Event Log
I N S T A L L A T I O N 3. W panel features guide M A N U A L 3.6 Read the event log EVENT OK or YES When user disarms the system, the keypad indicates the last event. -
Page 21: Ethernet Parameters
PING REPLY: Enables ping response. • Time Out Server: In case of disconnection to the local Network, the panel will try after that time to re-connect. • Max Seg. Size: Maximum size of packet sent. W and WIP Panel www.videofied.com... -
Page 22: Transmitter Events List
5. Transmitted events list M A N U A L The W panel can be configured to enable or disable the transmission of specific events like alarms or malfunctions. The installer can modify the default sending settings for those events, although it will end the EN50131 standard compliance. -
Page 23: G3G Error Codes
When the panel is unable to find any signal, proceed to GPRS 132, ... • SIM card not activated level test in another location on site. You can also find the network state or condition of use by directly contacting your local operator. W and WIP Panel www.videofied.com... -
Page 24: Security And Certifications Notes
Compliant with the annex IV from the R&TTE 1999/5/CE Directive NF&A2P - 2 boucliers – suivant le référentiel NF324-H58 Matériels de sécurité électroniques, détection d’intrusion CENTRALE D’ALARME + TRANSMETTEUR Marque commerciale : Référence Produits : N° de Certification : Videofied Centrale WIP210 Videofied Centrale WIP220 Videofied Centrale WIP230 Videofied... - Page 25 Cet appareil est conforme à la Partie 15 des règlementations de la FCC et avec la norme RSS-210 de l’Industrie Canadienne. Son fonctionnement est soumis aux deux conditions suivantes : Cet appareil ne doit pas causer d’interférences nuisibles et Cet appareil doit accepter toute interférence reçue, y compris les interférences pouvant entraîner un fonctionnement indésirable. W and WIP Panel www.videofied.com...
-
Page 26: Technical Specifications
North American Headquarters EMEA SALES 1375 Willow Lake Blvd, Suite 103 23, avenue du Général Leclerc Vadnais Heights, MN 55110 92340 BOURG-LA-REINE FRANCE E-Mail : usasales@rsivideotech.com E-Mail : emeasales@rsivideotech.com W and WIP Panel www.videofied.com...