4A- Ip7Ww-082U-B1: Connect The External Paging Device; 4B- Ip7Ww-308U-A1: Connect The External Paging Device - NEC SL2100 Quick Install Manual

Connecting External Paging to the Interface card

4a- IP7WW-082U-B1: Connect the External Paging Device

The SL2100 supports External Paging via the Audio Out port of the IP7WW-082U-B1 card.
The SL2100 supports up to three External Paging outputs.
Each IP7WW-082U-B1 card supports one
audio output, additional IP7WW-082U-B1
cards are required for additional audio outputs.
The audio output ports are setup within the
system configuration.

4b- IP7WW-308U-A1: Connect the External Paging Device

The SL2100 supports External Paging via the Audio Out port of the IP7WW-308U-A1 card.
The SL2100 supports up to three External
Paging outputs.
Each IP7WW-308U-A1 card supports one
audio output, additional IP7WW-308U-A1
cards are required for additional audio
outputs.
The audio output ports are setup within the
system configuration.
Connecting to the RJ45 socket can be done using the adapters, cables or direct termination as shown in this
guide.
Audio Out for Paging uses pins 1 & 8 of the RJ45 socket.
The external device should conform to this specification.
Description Specification
Impedance: 600Ohm @ 1kHz
External
Nominal output level: 250mV (-10dBm)
Paging output
Maximum output level: 1V RMS
Quick Install Guide – SL2100 MOH and External Audio rev 1.1
8