Connectors - Motorola MPx220 Service Manual

Disassembly
Removing and Replacing the Camera-module FPC and Flush-light FPC

Connectors

26
1. Remove the battery door, battery, front housing cover, upper PCB, and receiver as
described in the procedures.
2. Lift the camera-module-FPC connector cap up and disconnect the camera-module FPC
connector away from the upper PCB as shown in Figure 15.
Camera-module!
FPC Connector
Camera-module-
FPC Connector Cap
Figure 15. Removing the Camera-module FPC Connector
3. Push the flush-light-FPC connector cap a little bit toward the speaker and disconnect the
flush-light FPC connector away from the upper PCB as shown in Figure 16.
Flush-light-FPC
Connector Cap
Figure 16. Removing the Flush-light FPC Connector
4. To replace, press the flush-light FPC connector into place and push the flush-light-FPC
connector cap a little bit toward the external display to lock the FPC connector.
5. Press the camera-module FPC connector into place and push the camera-module-FPC
connector cap down to lock the FPC connector.
6. Replace the receiver, upper PCB, front housing cover, battery, and battery door as described
in the procedures.
December 22, 2004
External Display
Flush-light FPC
Connector
Speaker
MPx220